Execute Commands Using Change Advisor

Commands output by Change Advisor can be executed on the device. Double check the command you want to run before executing the suggested command. If an incorrect command is antered, you can directly edit the output command.

To proceed, click [Run], then [Yes].

You can check the result after executing the command. Change Advisor execution results and history are also displayed in the job history.

i Note:

TFTP is the primary communication protocol for Configuration Restore and Draft Configuration upload. Therefore, restore and upload functionality is not available on devices that do not implement TFTP. However, the Change Advisor function can be used by most models as long as CLI login (telnet/SSH) is supported. Therefore, you can use the Change Advisor function as a substitute even in environments where uploading is not possible.